Quick Answer: When should I burn KSP?

Because a maneuver node assumes an instantaneous velocity change, a perfect burn is impossible; to get the best results, it is recommended to burn half of the time before the node and the other half directly afterwards.

What is burn time in KSP?

The game calculates burn time based on the last time you accelerated. So if your last burn was with your previous stage or at a low throttle, the game will calculate the burn time based off of that, not off of your current stage.

How do you lower Apoapsis?

Lower your apoapsis by burning retrograde (see navball) at your periapsis. Raise your apoapsis by burning prograde at your periapsis instead. Lower your periapsis by burning retrograde at your apoapsis. Raise your periapsis by burning prograde at your apoapsis.

What is advanced Tweakables in KSP?

Advanced Tweakables Button adds a button to the KSP Application launcher that allows you to toggle the Advanced Tweakables option in KSP 1.2+ without going to the settings dialog.

How do you focus on a ship in KSP?

You can use the backspace key to focus on your current ship. This should reset the zoom level as well as the position. As of May the 4th (the time of my checking and verifying), the key used to focus the active vessel is the back quote: ` . They changed it to ` (also the ~ key).

IT IS INTERESTING:  How do you increase thrust in KSP?

What is prograde KSP?

The chartreuse yellow prograde marker indicates the orientation of the velocity vector of the craft relative to the point of reference; it indicates in which direction the vessel is moving at that moment. … Burning in the prograde direction will accelerate the craft, while burning retrograde will slow it down.

How do I take a crew report in KSP?

While you’re on the ground, we can complete one of the contracts that you accepted earlier by asking Jeb to take a crew report:

  1. Right-click on the Command Pod, and click Crew Report. …
  2. Enable guidance control by pressing T. …
  3. Launch your rocket by pressing the space bar. …
  4. Immediately tilt to about 45 degrees using the D key.

How do you transfer fuel in KSP?

To transfer fuel you will have to dock your vessels. This can be done either using docking ports on both vessels or a “grabbing unit” aka the “claw” on one of them. You will also need to have at least one upgrade of the science facility back at the Kerbal Space Center to enable resource transfer.

How do I use Mechjeb?

Once you have added the Mechjeb part to the rocket, there is a pull down menu at the top of the screen. Pull it down and select the ascent guidance (ascent autopilot?). click on engage and then activate your first stage.

What is a prograde burn?

A prograde burn is one in that direction, i.e. that adds to the ship’s orbital speed. The effect of a prograde burn is to raise the orbit’s altitude (opposite the ship’s current location); it is thus used when moving to a higher orbit, or when leaving a planet or moon completely.

IT IS INTERESTING:  You asked: Are elite dangerous saves local?
Playing into space